I have separate rear turn signal and brake lamp lenses in my car. How can this be done using your kit?

This is actually far easier than you might have imagined. Our systems all incorporate a light blue “third break lamp” wire which is doubled up with the white “break switch” wire that comes off of the cold side of the brake lamp switch (the orange wire at the switch is the hot side). Simply clip the white wire from that connection and your brake lamps will no longer work through the turn signal switch. Route that light blue “third break lamp” wire to the rear of the vehicle and wire in it into your brake lamp sockets. Next, install the rear turn signal and tail lamp wiring according to our instructions. By doing these few simple things, your turn signals will now work totally independent of the brake lamp switch.